3D scanning in
Princeton, NJ.

3D laser scanning in Princeton, NJ

Corporate and institutional research buildings out along the Forrestal campus and the Route 1 corridor need above-ceiling MEP documentation and equipment route studies, usually with controlled-access rules and explicit data-handling requirements written into the scope. University buildings nearer Nassau Street run on the academic calendar, and much of that older campus stock is historic enough that renovation starts with a measured model rather than a drawing set. The downtown commercial and institutional core adds preservation-grade capture where façade and interior ornament matter as much as the dimensions.

The building sets the method; the decision sets the deliverable. Some jobs end at the point cloud measurement on its own, some at dimensioned 2D CAD as-builts, and some need an IFC BIM model the trades can clash because three trades are about to work in the same ceiling. Where the roof, yard, or site grade matters, a drone mapping flight is flown on the same visit.

Princeton sits inside our New Jersey service area, so mobilization is short and a return visit for a phase-two capture does not mean rebuilding the whole job. Most work here is scheduled within days rather than weeks, including nights and weekends for occupied buildings.